I would like your opinion on a wooden work bench finish .

I built my first bench out of #2 pine 2×4 on edge. Ran them through a table saw to get the sharp edges on one side. Then glued and nailed them together to form a 3 X 8 foot bench. Now to finish it.
It is soft wood so that is an issue. I use the bench for about every thing building furniture to building honey due stuff.

I have a pottery project that went through the bisque firing. In doing so, it came out in two pieces. I glued them together with clear Loctite Power Grab. Unfortunately, there are a couple areas where the surface isn’t smooth.

My intention was to use the epoxy resin just to even the two uneven areas and when dried, paint it with acrylic without the unevenness showing.

I guess my question is, can I use the epoxy on just two areas and not the entire project?

Also, would you be so kind as to provide the directions for using the foam roller brush and squeegee? In this article you mainly discussed brush application.

I know I’m asking a lot, however, I could really use your expertise.

Thank you.

Did you ever find a replacement and if you did where did you get it?

I put new 1/2″ plywood down over the old T&G subfloor…lots of screws!

I am putting down bamboo.

Thanks

For optimal holding capacity, 2 pieces of 3″ or 3 pieces of 2″ door hinge will support the cabinet door with a weight of around 5 pounds.